Search results for "Signal generator"
showing 10 items of 17 documents
High-Power Multicarrier Generation for RF Breakdown Testing
2017
Testing of satellite components for high RF power breakdown effects, such as multipactor and corona or passive-intermodulation, is a topic of growing interest in the aerospaceindustry. Switching fromthe classical single carrier approach to the more realisticmulticarrier scenario is very challenging from the experimental point of view. Themulticarrier signals, amplifiedby several RF power amplifiers, need to have controlled phase, amplitude, and frequency in each carrier. Fine tuning of the signal generator phases is required in order to compensate the phase drift occurring in the active elements of the test bed. This paper presents an efficient and low-cost technique to generate multicarrie…
A parametric analysis of the transient behavior of lightning protection systems
2005
The paper have the purpose of investigate the influence of different parameters to enable better understanding of the transient performance of complex lightning protection systems (LPS). Lightning discharges constitute the major source of atmospheric or natural noise that can interfere with electric and electronic installations. The electromagnetic characterisation of the LPS environment plays a fundamental role in order to prevent unwanted coupling phenomena that may generate abnormal signals, electric stresses dangerous for the insulation of electric components, disruptive discharges and danger to persons. The model, developed by the authors, is based on a field-approach: the numerical so…
Design of a configurable multispectral imaging system based on an AOTF.
2011
In this paper, we present a configurable multispectral imaging system based on an acousto-optic tunable filter (AOTF). Typically, AOTFs are used to filter a single wavelength at a time, but thanks to the use of a versatile sweeping frequency generator implemented with a direct digital synthesizer, the imager may capture a configurable spectral range. Experimental results show a good spectral and imaging response of the system for spectral bandwidth up to a 50 nm.
Design, sizing and set up of a specific low cost electronic load for PV modules characterization
2013
In this paper, the design, sizing and set-up of a specific low cost electronic load, based on a DC-DC step-down converter, suitable for the PV module I - V characteristic curves determination, is described. In particular, for its set up, a low cost and user friendly micro-controller has been employed in order to generate the PWM signal. The measures carried out connecting the electronic load prototype to a commercial PV module are here presented and discussed. The conceived electronic load has allowed the determination of 80% of the PV module characteristic curves in 2 s. This low measurement time, lower than the time intervals in which weather conditions may change, allows to assume as con…
A Novel Method of Distance Measurement Based on Pulse Position Modulation and Synchronization of Chaotic Signals Using Ultrasonic Radar Systems
2009
This paper deals with a novel method of transmission and receipt of a signal based on both the property of two chaotic systems generating the same chaotic signal when they are synchronized and the property of pulse position modulation (PPM) to be insensitive to the distortions of the transmission channel. The method is discussed in the context of ultrasonic radar systems, in which the transmitter and receiver, which consist of ultrasonic sensors, are near each other, and the received signal consists of the transmitted signal reflected by an obstacle. A reference sinusoidal signal is superimposed to a chaotic signal generated by a master chaotic system, and the whole signal is modulated acco…
Photonic waveform generator by linear shaping of four spectral sidebands
2015
International audience; Changing the optical phase difference between four spectral sidebands is sufficient to synthesize various pulse shapes. Experiments at 40 GHz confirm that high quality parabolic, triangular or flat-top temporal intensity profiles can be achieved.
Low-noise microvolt level calibrator for measurement of performance of biosignal recording systems
1997
A calibrator, the noise level of which is below the noise level generated in the preamplifier system, was needed for testing and development of a multichannel recording system. A multichannel preamplifier head assembly was used for recording cortical, subcortical, and cerebellar slow potentials and multiunit activity in freely moving cats and restrained rabbits. An inexpensive, battery-powered, lownoise voltage signal generator for calibration of the preamplifiers is described. The circuit provides a square-wave output at a frequency of 10 or 1000 Hz, and the peak-to-peak (p-p) amplitude can be selected at 10, 100, or 1000µV. The measured output noise of the calibrator is below 2µV (p-p, 0.…
Photonically assisted RF generator with incoherent sources
2008
An RF waveform generator operating with incoherent broadband light is successfully implemented. Complex RF ~10 GHz bandwidth waveforms are generated by means of incoherent wavelength-to-time mapping. Our technique can be scaled to the mm-wave range.
Reconfigurable RF waveform generation using optical incoherent sources
2008
An RF waveform generator operating with incoherent broadband light is successfully implemented. Complex RF ~10 GHz bandwidth waveforms are generated by means of incoherent wavelength-to-time mapping. Our technique can be scaled to the mm-wave range.
20 GHz arbitrary radio-frequency waveform generator based on incoherent pulse shaping
2008
We demonstrate a new approach of photonically assisted radiofrequency (RF) waveform generation using a spectrally incoherent light source. The system is based on the so-called generalized frequency-to-time mapping operation. In this work, external modulation of the source is done by concatenating two electro-optic Mach-Zehnder modulators properly biased to achieve short pulse gates which allow for broad bandwidth electrical signals. Also, the spectral shaping stage is performed prior to O/E conversion. A detailed theoretical analysis demonstrates that even in this case the frequency-to-time mapping is preserved. The key is that the noise level is greatly reduced because the amplitude filter…